Our aircraft.
Closeup of the engine.
Internals of airplane: radio-control operation.
Radio-control transmitter.
Closeup of the aileron servo mounted on the bottom of the wing.
Part of (unfinished) PCB layout - the central section where Snapper is mounted.
Reflow soldering of one of the BGA gyroscopes in a temperature controlled toaster oven.
The assembled IMU daughtercards mounted on the main board.
Temporary modifications required to the power supply because we ordered the wrong part.
The main PCB as it is orientated in the aircraft.
The main PCB again.
All our equipment set up prior to a systems test.
John driving the aircraft around during a systems test.
The airframe with electronics mounted and in testing.
Albatross gracefully not falling out of the sky.
Flight test group, John, Hugo, David and Andrew.
The groundstation successfully recieveing data from Albatross in the air.